on 05-24-2014 8:08 AM
Hello,
I am trying to use Physical Sample Management in SAP for Inspection
Lots with Inspection Type 04. Every time I create an inspection lot, my lot
stays in Created mode. Here's my data.
I created a Sample Drawing
Procedure with the following info:
Lot Container: EA
ToPartSampleNo:
1
Sample Container: PALLET
Size Factor: 1
Fixed Number: 2
I
SAMPLE SCHEME
lot size-30
sample size-29
c1-21
d1-22
also created a Sampling Procedure with the following:
Sampling Type: 300 USE SAMPLING SCHEME
Sample
Valuation Mode: 100
Inspection
Points: Sample Management
Sample Size: 3
I assigned Inspection Point
200 and the Sample Drawing Procedure to the header of my Inspection Plan.
Is there something I am doing
wrong?
lot is generated but unable to go ahead.
What are the current statuses that show on the inspection lot?
Craig
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Sanket,
The system searches for inspection plan each and every time you created the inspection lot, have you created inspection plan with QP01? Pls check and revert.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
89 | |
7 | |
6 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.