on 05-16-2014 5:46 AM
Hi Experts,
I am looking at an issue where the system sets the deletion indicator automatically once requisition is released and PO created against it
I tested by creating a requisition, releasing it through ME54N and then creating a purchase order by copying it......once PO is created the requisition has a deletion indicator
I have tested requisitions with account assignment category as Cost center & work order and in both cases I see this issue
Can you throw some light what might be causing this?
Thanks
Dear Mujju,
There is no other reason except BADI, kindly ask you Abaper for this.
Best Regards
Mohsin Abbasi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Once the TECO is completed for for maintenance order it will have PR status as deletion.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi,
are you using PM module an this PR created for PM module, if this is the true then it may be possible that system make automatically deletion indicator to PR once PO created against .
Regards,
mukesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Mukesh Kumar can you explain how this is done from PM module? Is there a job that monitors for which PR a PO was created and sets then the deletion indicator?
This is not a standard behavior.
Can you check is there any development implemented in your system. Ask your abaper to check the program.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
7 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.