SAP PM Task List

[former_member186967]

Dear Experts

I have the following client requirement

In the Instrumentation Department there are many Transmitters of different ranges(0-200, 0-300,0-10 etc). They will calibrate those equipments in the following manner

  let us take an example of transmitter of range 0-200deg

  First they will give the value of 0deg to the transmitter and check the output. it must be in the range of -1 to 2. next they will give the value of 25 deg and check the output It must be in the range of 23 to 26. In the same manner they will check for 50deg, 75deg, 100deg. Like that they will check for different equipments of different ranges. So How can i map this process in sap for calibration process. I am new to sap So I am requesting to help me.

Thanks in advance

Ravi

[Former Member · Accepted solution]

1. Create MIC in QS21 for 0 deg, 25 deg, 50 deg, etc., such as wherever you want to check the reading. Keep description appropriately which shows the input degree. Maintain the lower limit, upper limit & target value for that MIC. MIC should be as Quantitative.
2. Create Task List (IA01 / IA05) separately for different range equipment & mention one operation as Transmitter Calibration and assign the desired MIC to that operation. Mention Inspection Point as 300 in Task List header.
3. Create Calibration Order type by assigning Inspection type 14 to that. OR use PM06 order type
4. Create Calibration Order in IW31 & assign the task list created for that transmitter
5. While releasing, Inspection lot will be created. Record the results in QA32.

Note: There are many threads discussed about calibration process. So, search in google as "Calibration".

[former_member186967 · Accepted solution]

Dear Sir

Right now I am following the same process you have suggested. But there more than 3000 equipments of different ranges and different properties. So Should I upload task list for each and every equipment of different range? , Or else Is there any other alternative?

Thank you

Ravi Tej

[Former Member · Accepted solution]

As you mentioned that each equipment is having different parameters, its better to use BDC Program to upload the task list.

If these are equipment specific ranges & parameters, then go for Equipment Task List.

Else, you can use General Task List.

[former_member186967 · Accepted solution]

ok sir. I will use BDC to upload task list.

Thanks for immediate response

Ravi Tej