I am doing a File to RFC async scenario. I have done the related development in ESR and ID. While testing the file adapter picks the file does the required content conversion and is successful . When I check the RFC adapter it also shows successful. But the problem is the payload is the same as it was in the sender adapter. I mean after mapping the payload must change to the target message. Somehow in the RFC adapter I am seeing the same source payload. I deleted the Service interfaces, deleted the channels, deleted the ICO and recreated everything again but still the same issue. Can someone please provide inputs on the same. All configurations look correct. Ideally the message has not reached ECC but atleast the payload conversion should have happened.