Skip to Content
avatar image
Former Member

After BI 4.1 configuration in SOLMAN - error message "The systems you selected do not contain any software components currently supported by E2E Workload Analysis"

Hi All,

I'm trying configure E2E monitoring. I configured all necessary steps, I can see my BI 4.1 system in SLD, also in SOLMAN, all “lights” are green. But if I start Root Cause Analysis>> Ent-to End Analysis>> My system>> Workload Analysis, I see this error "The systems you selected do not contain any software components currently supported by E2E Workload Analysis".

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • May 20, 2014 at 01:46 PM

    Dear customer,

    It sounds like the BOBJ components are not checked as "diagnostic relevant".  I would check the technical system in LMDB and confirm that the correct components are checked as diag relevant per the following wiki page

    http://wiki.sdn.sap.com/wiki/display/SMSETUP/Managed+System+Setup+of+BOE+4.0+system+in+Solman+7.1

    It would be helpful for SAP to connect to your system via SAProuter.  You can use component SV-SMG-DIA for help by SAP support

    Regards
    Toby

    Add comment
    10|10000 characters needed characters exceeded