on 04-24-2014 6:58 AM
Dear All,
I have created one finished product and one raw material. In Master Recipe i created one Phase and assign two instruction category CONS_1 and PROD_1.
Now i generated PI sheet in COR2 and see CO53 that it is present and now i send it and in CO60 it is there.
Now when i see and enter quantity in PIsheet and double click on it to see the Process Message
1) PI_PROD has material number of finished product - It is ok
2) PI_CONS has also material number of finished product but it should have raw material number.
So, my issues are
1) How raw material will be there in PI_CONS Process Message.
2) Should i create two phase and assign it one by one or what else.
3) If i have Process Order of 500 quantity and through PI Sheet i do GR of 10 and GI of 10 then for next time how should i do GI and GR again. Should i send PI Sheet again from CO53 to CO60.
4) Is there only one control Recipe is generated for one process order.
Hi,
process instruction CONS_1 will not show raw material number it will show reservation number of the process order...instead of using CONS_1 use CONS_D and use this control recipe destination and make the settings as shown below...
your final PI sheet output will be like this....
Hope this helps...
Thanks
Kumar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear K Kumar,
During Control recipe creation through process order it is giving the following error
1) no values assigned to char. 0100 PPPI_Material_Consumed
2) no values assigned to char. 0120 PPPI_UNIT_OF_MEASURE
3) no values assigned to char. 0050 PPPI_MATERIAL
I have not given any value in master recipe of finished material. Why value is not assigned to it automatically. Should i give it.
Regards,
Saurabh
Dear Experts,
Please answer it.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
103 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.