Can't configure SWU3 Classify Decision Task as General in Quality

[Former Member]

Hello Workflow Gurus,

I have successfully completed SWU3 configuration in development, however, in quality I am not able to. I have not been able to complete two tasks:

• Classify Decision Task as General
• Document Generation/Form Integration

I can not configure these two manually or automatically, I get the following message:

Client 700 has status 'not modifiable'. Choose 'Display object' or 'Cancel'.

How can I configure these two tasks in quality?

Me, as workflow and ABAP consultant and a BASIS contact have tried to configure this. Thanks for any help in advance, points will be awarded.

Best Regards,

Gustavo Yong

[I042439 · Accepted solution]

Hi Gustavo

Please ask Basis to temporarily allow maintenance in this client, do the config and set back the basis settings for maintenance.

Regards,

Modak

Message was edited by: Modak Gupta.................... Basis settings in transaction SCC4

[Former Member · Accepted solution]

Thanks for the reply Modak, I have modified the settings in SCC4 and have successfully finished SWU3 configuration. For these two tasks I was asked to create a customizing transport, do you know if I can release this transport to production or this configuration also has to be executed manually in production (using SCC4 to temporally allow changes)?

[I042439 · Accepted solution]

Hi Gustavo

Please check with basis if its okay to transport a TR just from Q to P.

Normally, SWU3 config asking for transport happens based on the settings you chose in SCC4. Now for your case, there was no TR from Dev, but one from Q -> check with basis if it will not cause any conflicts.

Else you have this solution available when production is setup first.

Regards,

Modak