Skip to Content
0
Former Member
Apr 22, 2014 at 08:20 AM

QM Manual Inspection Lot - with Inspection lot origin 89

1716 Views

Hi QM Guru,

I did maintain inspection type 10 in this material but while i would like to create the inspection lot manually.

I try to create manual inspection lot manually , i encounter this error with Inspection lot origin 89.

----------------------------------------------------------------------------------------------------------------------------------------------------

No valid inspection type for material 10000037 was found or selected

Message no. QA280

Diagnosis

An active inspection type for the material 1XXXXXXX in plant XXXX could not be found for the specified origin 89 or none of the available inspection types was selected.

System Response

Inspection lots cannot be created.

Procedure

Check the inspection type setting in the material master.

Is there anything which i missing ?

Thank you.