Skip to Content
0
Former Member
Apr 09, 2014 at 09:19 AM

Product Group capacity can not be seen in MF50 output

444 Views

Dear All,

I can not see the product group in 'total capacity' subscreen in output of planning table MF50.

In MF50 the input parameter i am entering is product group and plant.

In the scheduling tab of input parameters detailed scheduling and capacity planning is tick.

For some product groups i can see in output as "Product Groups / Total Capacity" and also in the rows below it shows "Prod.Grp XYZ" then requirement and available quantity rows. After which the production line rows follows.

For some product groups when enter in initial selection screen of MF50 with same input parameters in output i do not see Product group but i can see "Total Capacity Data" and then the rows starts with production lines. But no information on capacity of product group.

The setup of all product group is same and are created with MM01.

Regards,

Vero.