on 03-26-2014 12:29 PM
Hi,
As per standard document we have done all the needful thing things in SXMS_LMS_CONF tcode .Selected extract with external job as well.
Now while indexing in se38 by executing the report SXMS_EXTRACT_MESSAGES we are not getting any logs .More over when we test in SXMB_MONI/user defined selection criteria it was not able to filter though the message exists in sxmb_moni.
Could you please advice where I'm missing.
Regards
Venkat
Hi,
By default UDMS in abap stack for synchronous messages don't work .
We need to comment a line in the report SXMS_EXTRACT_MESSAGES to make it work .
Regards
Venkat
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Venkat,
After configuring,Did you check whether the message is filtered in Test search criteria by giving the message id.If its not extracting then something wrong in the configuration of UDS.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Venkat - While adding the interface, usually the active button is disabled. But after adding the filter to it(xpath), then the "Active" button gets enabled.. So cross check if the "Active" check box is selected..
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Venkat - Did you add the receiver system component or using"*" ?
Have a look at the below SAP Note # 1600078 - Additional information about user-defined search
btw.. what is your PI version?
User | Count |
---|---|
83 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.