Stock transfer between two St locs of same warehouse

[Former Member]

Hi All,

I am new to WM and trying to config/simulate st loc to st loc transfer 311
one step between two st locs that belong to same warehouse number.

What should be the config and under
LE->WM->Interface->IM->movement types -> assign WM Movement Type
References to IM Movement Types. In my system for 311 movement type entry with
only the quantity check box checked and no other spl stock I see that there are
three columns mentioned below

For mvt types on WM side first one “Reference movement type for WM from
material movements” = 311

Second one “Reference movement type for transfer in warehouse mgmt.” =312

Third one “Reference movement type for posting change in whse mgmt.”=309

The reason I am confused is when I do a MB1B 311 from one st loc to another
st loc from unrestricted to unrestricted on IM side it is triggering 309 on WM
side where as I am expecting 311 to trigger with TR to pick from issuing St loc
and another TR/TO with (312 or 311 I am not sure) to putaway the stock in to
the receiving st loc. Can someone help in explaining how should the stand SAP
IM/WM interface work and what should I be doing to make it work that way

Thank you in advance

J

[milind_tapare]

Hi J,

To explain you in simple way,

When Sloc is Wm managed and stock is transferred at IM level using 1 step within plant, stock is directly transferred from one sloc to other sloc(no TR/To is created to pick and putaway unless configured)  Due to this difference is created between IM & WM level, Hence mvt type 309 is triggered for PCN . This Mvt 309 is picked based on std config at

LE->WM->Interface->IM->movement types -> assign WM Movement Type

References to IM Movement Types

If you want to create TR immediately then put x in 9 column against mvt 309 and w/h combination.

LE->WM->Interface->IM->movement types -> LE-WM Interface to Inventory Management

[JL23]

Please read OSS note 388909 - From the movement type in IM to the movement type in WM

it explains how SAP is looking for the WM movement types

[Former Member]

Thank you Jurgen. Will review the note and verify if config is correct

J