Skip to Content
avatar image
Former Member

Why do we need material specification for transfering results to class char.

Hi,

Can you guys tell me why do we need to create material specification if we want to transfer quality inspection results to a batch class?

Basically I have done the following:

-Create Class Characteristic

-Assign the Class Characteristic to a batch class

-Link Class Char.  to MIC

-Assign MIC to an Inspection Plan

-Post GR, batch and inspection lot are created automatically

-Record Results for inspection Lot

-Make UD for Inspection Lot

The result is not transferred to batch class, then I create material specification with the MIC assigned, the results can be transferred. But why?

Best regards

Danny

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Mar 13, 2014 at 03:02 AM

    Hello wang,

    You need not to if you flag Batch Valuation without material specification indicator in Plant dependent settings for QM> InsLot completion.

    Amol.


    Batch.JPG (41.2 kB)
    Add comment
    10|10000 characters needed characters exceeded

    • Hello Danny,

      This is a standard program, which checks for this indicator at the time of inspection lot completion.

      F1- help gives satisfactory explanation

      Batch Valuation Possible Without Specification

      Use

      If you set this indicator, a link between the master inspection
      characteristics and the class characteristics for the batch class must exist
      when an inspection lot is created, for batch valuation to occur when the usage
      decision or inspection point valuation is made. A link within the material
      specification is not required.

      If you do not set this indicator, batch valuation only occurs when the
      usage decision or inspection point valuation is made, if a link using the
      material specification exists between the master inspection characteristics and
      the class characteristics for the batch class. In this way, you can control on a
      material-dependent basis whether the batch characteristics are valuated based on
      the inspection results.

      Amol.

      Message was edited by: Amol Manave : Main purpose is you can control whether Batch characteristics should be valuated based on results or not for particular material. If you set this indicator then batch characteristics will be valuated for all materials and in opposite case Batch characteristics will be valuated for only materials for which Material Specification exists.