Skip to Content
avatar image
Former Member

PhaseIbdicator problem.

Hi Guys,

On <b><u>run time</u></b> in a PhaseInticator control there are 2 buttons for moving

Can somebody explain me how can I use these buttons.

Evgeny

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Nov 10, 2005 at 01:27 PM

    Evgeny,

    See my reply to the same question:

    phaseindicator-next-and-previous-phase-buttons

    VS

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 10, 2005 at 01:20 PM

    Hi Evgeny,

    Those two buttons are basically provided as paginators to move between the set of phases. If the no: of phases in the phaseindicator is more than what can be shown within the current width of the Indicator, then the phases will be divided and shown in sets. These buttons are provided to move between these sets of phases. So these buttons will be active only of the no: of phases is more than what can be shown at a time by the indicator.

    Hope this helps,

    Best Regards,

    Nibu.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 10, 2005 at 01:26 PM

    As already explained correctly, these buttons are for paging if there is not enough space to show all phases.

    You cannot add actions to these buttons.

    Armin

    Add comment
    10|10000 characters needed characters exceeded