cancel
Showing results for 
Search instead for 
Did you mean: 

Unable to pack

Former Member
0 Kudos

Hi all,

I am doing a outbound delivery from a WM, SU managed storage location. During confirmation of TO i am getting the following error.

An internal error has occurred (L03T 0114 V )

Message no. L3705

Diagnosis

No screen sequence control is defined for the argument enclosed in parentheses in the error message.

Procedure

Contact your system administrator about this error.  Note down the parameters in the error message and the situation that caused the error.

Have any one faced this issue before, how to resolve this?

regards,

Sayantan

Accepted Solutions (1)

Accepted Solutions (1)

JL23
Active Contributor
0 Kudos

SAP is looking for an entry in table T342, if it cannot find one according to the selection then this error is issued. The code is in program MLLVSFOR

does this error come up in a standard transaction, or in a modified transaction?

Former Member
0 Kudos

Hi,

Thanks both Jurgen and Mehmet i missed one a configuration and the packa HU was a different one which is to be taken.

The issue is resolved now.

regards,

Sayantan

JL23
Active Contributor
0 Kudos

If you dont mind, could please post what you did in more detail. You probably saw that this question was asked a few times before and all had quite many readers. But none had an answer, except " solved by myself" .   I cleaned all such questions. So this one could become the single one with THE ANSWER

shanuvaibhav
Explorer
0 Kudos

This message was moderated.

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi Team,

Sorry for a delay in response, caught up with daily project works

There are two things which i checked and solved out my problem. The notes and the program given in the post are relevant, all these should be checked additionally.

1) Check the HU packageing material type and the material which is to be packed. Check if both of them are maintained correctly .

This will solve the primary issue. if any configuration related to the material material type and pagaging group is missing ,configure it.

In the secound case check the item catergory configuration.

Define Item Category Determination in Deliveries>

LF + VERP + PACK = HUPM / DLN

regards,

Sayantan

former_member183155
Active Contributor
0 Kudos

Hi Sayantan Pal ;

Can you correct me if i am wrong ?

1- Material Type Configuration --> OMS2 --> Check LEIH (Returnable packing) material type--> Item catagory group must be VERP

2- Item Catagory Determination in Deliveries

   Configuration table --> T184L

    But , i think that you can use TAL item catagory ...

Regards.

M.Ozgur Unal

Former Member
0 Kudos

Hi Mehmet,

This assignment will also go. If you look closely LF is outbound delivery type but the TAL is used as a ( returnable packaging).

I have written which will you find in any standard. In my project i have a custom delivery type and SIT in place together.

There are other item cat which may be assigned like

ELP: Inbound delivery packaging

HUPM: this will come as an additional item in the delivery line

DLN: Standard item without order

TAL:  Returnable packaging.

It depends how you are configuring, and if it is inline with your scenario.

While talking on OMS2 you might have also seen that there is another material type VERP (packaging) there also you will also find VERP as mandatory.

Thanks,

Sayantan

NB: Thanks again for the notes which you have given.