on 02-23-2014 3:16 PM
Hello,
When I am doing the UD i can see a lot of folders with UD code (01,0101, 04,08, 14) and I only use some of them. Could you please advise where can I change the setting so more of them were not displayed? I would like to se 01.04,08 only?
Thank you in advance
Regards
Mark
Hi Mark,
First you need to create Selected Set.
Go to QS51 select catalog type "3" usage decisions , enter plant and Selected set example UD_01. This is for inspection 01. Like wise create for each inspection type as displayed below:
Now you need to assign the Selected set to the inspection type
Go to SPRO - Quality management - Quality Inspection - Inspection lot creation - Maintain Inspection Types. Select inspection type 01 and assign the newly created selected set (UD_01) here at the field "UD selected set" as shown below.
Now system will display only those codes that are covered under the selected set UD_01 for inspection type 01. Similarly you need to create for all rest of inspection types.
Note that you can assign only selected set to one inspection type.
Thanks & Regards,
Ramagiri
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
7 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.