EDI:Partner profile not available

[Former Member]

Hi folks,

I am working on the scenario jdbc to idoc.I had done ALE settings also.Eventhough i am getting the error"EDI: Partner profile not found". I searched many blogs ,but could't find where the error is. Will you please rectify the problem.

Regards,

Dileep

[Former Member]

This message was moderated.

[Former Member]

Hi subhajit,

I am new for sap pi ,please let me know the solutions for the following queries.

1. while using jdbc on sender side,is it required to maintain logical system (LS) for sender system.?

2. In jdbc to idoc scenario ,how many partner profiles& ports we will create on both ecc and pi system?

3. while implementing we02 in ecc, in technical info it is showing the partner number and port which i had n't mentioned in ALE or anywhere.Can anyone make it vivid.?

I am confused of doing these things.please give me a clear picture.

Regards,

Dileep

[former_member191435]

Hi Dilip...

1. while using jdbc on sender side,is it required to maintain logical system (LS) for sender system.?

If your sender system is a Business System then you need logical system..If it is a Business Component you dont need LS.

2. In jdbc to idoc scenario ,how many partner profiles& ports we will create on both ecc and pi system?

You have to create ports and partner profiles for IDOC .

JDBC to IDOC Scenario | SCN

Please check below for the usage of IDOC and JDBC

http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/d09cb520-f883-2c10-56b9-adb6d9182...

Thanks,

Srinivas

[abhradeepbasu]

Hi Dileep,

1. Please check your IDOC Control records first properly (EDIDC 40). You will get the values for the partner number,type,sender system,port etc.

2. Go to ECC: t-code: we20 and configure your partner profile based on the values you find in your step 1.

3. Now re-trigger and check the results.

/A.B

[Former Member]

Hi Dileep,

check below blog whether you followed all the steps mentioned in the blog

SAPTechnical.COM - Step-by-step guide to ALE and IDOCs

[gagandeep_batra]

hi Dileep:

AS error says "Partner profile not found" can you check have you create partner profile in  ECC with corespondent to sender system

[Former Member]

Hi Gagandeep,

I am new for sap pi ,please let me know the solutions for the following queries.

1. while using jdbc on sender side,is it required to maintain logical system (LS) for sender system.?

2. In jdbc to idoc scenario ,how many partner profiles& ports we will create on both ecc and pi system?

3. while implementing we02 in ecc, in technical info it is showing the partner number and port which i had n't mentioned in ALE or anywhere.Can anyone make it vivid.?

I am confused of doing these things.please give me a clear picture.

Regards,

Dileep

[Former Member]

Hi,

Is this the first interface to connect to that particular sender system ? If yes then you need to create partner profile for the same in ECC (WE20) and maintain the same partner profile name in SAP PI/sender business component/adapter specific configuration/logical system.

Regards

Venkat

[Former Member]

Hi ,

First make sure ,IDoc reaches to ECC system or not .If it reached to ECC then it is not the problem with PI.

Now in ECC WE20 check whether partner profiles are maintained properly or not .

Regards

Venkat