Skip to Content
0
Feb 04, 2014 at 04:05 PM

Issues with procedure debugger in rev 68

19 Views

Hi folks,

I am having a few recurring issues that are driving me to the brink of insanity. I was just wondering if anybody else has experienced these issues in 68 and if they have been fixed in 70?

1) My RUN/STEP INTO and RUN/STEP OVER options are not available and so I have to put breakpoints on every single line of code that I want to step through making it very cumbersome.

2) My variables inconsistently and randomly disappear throughout the debugging session. ie: As I'm stepping through my code (or in my case painfully going to the next breakpoint one line at a time) sometimes the entire variables screen goes blank. But the code is still executing. Sometimes it will be invisible for one line, sometimes several lines then magically re-appear.

Perhaps another case for upgrading to 70.

Thanks,

-Patrick