Skip to Content

automatic valuation with rejection and acceptance

Hi,

I am using sampling procedure with fixed sample qty say 5 qty. I am doing individual recording for a quantitative MIC... limits are 8 mm to 12 mm..Now valuation is automatic..now my requirement is among five samples if one or two samples are out of limits still system need to do acceptance valuation and if 3 or more samples are out of limits then system needs to do rejected valuation. How this can be achieved..I do not want to use sampling scheme.....

Plz gudie....

Thanks

Kumar

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    Jan 29, 2014 at 04:32 AM

    Hi,

    Have you looked at 'Acceptance number' while defining the Fixed sample size 5 in the sampling procedure ?  What have you maintained there?

    Try with 2 there. This is the maximum number of non-conf units that permits acceptance for an inspection lot.

    I'm exactly not sure if I followed your query.

    ntn

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jan 29, 2014 at 02:31 PM

    Hi Kumar

    Try the valuation mode attributive inspection with on conf. units or number of defects. Here we can enter

    Acceptance number.


    Regards

    Kesava

    Add comment
    10|10000 characters needed characters exceeded