digits are getting turncated in WWI reports.

[sujana_koduri]

hi Floks,

in the mean while i am generating the WWI report for the specfication created in CG02BD.But in the WWI report the value related to weights is getting truncated to only 5 digits but where this should not happen.Please refer marked part in below error in the figure .

Regards,

Ranjith.

[Ralph_P]

Hi Ranjith,

unlike Christoph, I think the measurements of the pallet are correct, this is slightly larger than an EPAL-pallet, which sounds OK. However, your conversion program is wrong as 1 lb equals 454 g. Further, this conversion program seems to deliver only 5 digits. Turn it off or take it out of the WWI symbol, then I think it should work.

Ralph

[sujana_koduri]

[christoph_bergemann]

Dear Ranjith

do you have attached to the report symbol a "conversion module" ? As in the screen below the value is:

"888.6992 kg" but then "88869 G" is shown; therefore there seems to be a conversion runnign from "kg" to "G"; I assume that the second part is lb in american pounds. And this conversion seem sto be wron as well. 888 kg gives 1957.70 pounds (if my conversion was correct) and the value shown in your report does have "no connection" which I can detect to the original value.

Document http://scn.sap.com/docs/DOC-45838

contains a subsection there standard WWI conversion routines are mentioned C14N_SYM_MASS_TO_KG and C14N_SYM_MASS_TO_LB. Did you use them?

Can you should definition of report symbol and how it is used in WWI layout?

C.B.

PS: changed content of thread a little bit taking into account the answer / comment of Ralph. Thank you Ralph for your comment.