SAP Manufacturing Integration and Intelligence (SAP MII) 14.0 will work on NW7.4 or Not?

[Former Member]

Hi Experts,

I installed MII14.0 on SAP NW 7.4 SR1.

My question is MII14.0 will work on NW7.4 or not. I checked in the PAM it shows only NW7.3 and NW7.31.

Where can i get this information?

Regards,

Surendra.

[salvatore_castro · Accepted solution]

Surendra,

The plan internally for MII is to officiall support NetWeaver 7.4 with MII 15.0 which is planned to go into Ramp-up in Mid-May of this year (Customer validation is planned ot start on April 1st).  This MII release will also support usage of HANA as the underlying DB and is the foundation for our MII on HANA feature for this upcoming release and is complemented by a native HANA SDA interface to MII to retrieve data ondemand from MII into HANA Virtual tables.

Other notable MII 15.0 features include the following:

1. HTML 5 UI Objects - Fully replace the applets for the UI
   • The applets will not go away, but the focus for development will be on the HTML 5 objects
2. Self-Service Composition Environment (SSCE) - Enable an end user to build their own reports or to define a layout and enable IT folks to further extend the reports via HTML & JavaScript
3. Remote Administration & Configuration of Plant Connectivity (PCo) - Remotely configure and manage agents defined in one or many Plant Connectivity instances and push informaiton from the Plant Information Catalog into the trigger and notification payload definitions.

Hope this helps,
Sam

[former_member193328]

Hi Surendra

Ideally all NW Versions should support applications developed on older platforms. So in principle MII 14.0 should run on NW 7.4.

However sometimes due to several reasons this may not be all true. Especially if you want to put NW 7.4 on HANA DB as this was never validated for MII 14.0.

For all traditional DB and OS combinations it should be relatively safer to try it out.

Regards

Partha

[rutika_bodas]

Hi Surendra,

Like you said, the PAM mentions only NW 7.3 and NW 7.31, that means that MII 14.0 on NW 7.4 may not have been validated and hence may not be possible.

You can rely on the PAM in such case.

Regards,

Rutika Bodas