Skip to Content

Engineering Record status: Workflow start

Hi all,

In an engineering record, as per standard, WF gets triggered for status 20. But we don't want this to happen, and want WF to be triggered for status 30. I checked the following SPRO settings, but was of no use.

Logistics(General) --> PLM --> Case Management --> Set status administration --> Create status profile (In status values, I have added the event).

Can somebody please suggest how this can be achieved.

Thanks in advance.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Jan 09, 2014 at 05:52 PM

    Hi Aiswarya,

    Logistics(General) --> PLM --> Case Management --> Set status administration --> Create status profile


    in last column event for case , make relevant settings


    e.g. if INPROCESS even which is triggering your workflow , remove it from status 20 and put the same for status 30.


    Further you can create condition for workflow event &Case.Status& NE 20 to avoid triggering at status 20 irrespective of SPRO settings.


    Thanks and regards

    Add comment
    10|10000 characters needed characters exceeded