PO 7.4 monitoring

[former_member15983]

Hi -

Can some one tell me where to look the payload after monitoring in SAP PO message monitoring. also in Message monitoring receiver interface and receiver service is not display and it is blank. Can you please help?

Thanks,

Prem.

[Muniyappan · Accepted solution]

Hi prem,

check this for monitoring messages.

check this for enabling pipe line steps to those in monitoing.

these are applies to po7.4 also.

Regards,

Muniyappan.

[former_member15983 · Accepted solution]

Thanks Muniyappan. You answered one part of the question. I asked the question that Emil asked too.

[Former Member]

Hi Prem,

Funny, I just decided to act on this thing today myself - having been frustrated by the missing receiver details for some time.

Unfortunately, the links provided by Muniyappan doesn't provide a solution for how to make these details visible idirectly in the overview monitor.

If I understand you correctly you also want the "receiver interface/namespace" made visible from the overview - and not just get a blank like in the picture below:

If anyone knows how to make the receiver interface/namespace visible in the empty column in the picture above, please let us know. Changing the settings for Logging and Staging in the Integrated Configuration does not help.

Thanks,

Emil

[Muniyappan]

Hi Emil.

links which i provided above are for only monitoring purpose. i did not mention it for  "how to make interface/namespace visible from the overview".

i think prem is asking to see the receiver side message.

if we have to see the output message which is produced after executing message mapping it is not possible without logging. hence i provided links for that. correct me if i am wrong here.

i guess next time onward i should mention my answers clearly.

Regards,

Muniyappan.

[Former Member]

Hi Muniyappan,

I owe you an apology. You answered Prem's question correctly and fully. I just happened to read Prem's question, so it matched my own issue. After a reread, I can see they are different.

I might open a new discussion regarding my issue with the "invisible" receiver interface/namespace in the message monitor overview. If anyone out there know the answer to that one, I would appreciate a reply.

Have a good one,

Emil

[Muniyappan]

Hi Emil,

Thanks for your reply. I really appreciate it.

Regards,

Muniyappan.

[former_member15983]

Hi Emil -

This is the first time am integrating in SAP PO single stack. I didn't the receiver service itself the message overview. but i see the message is successfully sent to the receiver system.

Thanks,

PRem.