on 10-21-2005 4:25 PM
I have a small BPM Scenario, in which I receive a message and Transform it and send it to the Receiver. It ran OK.
I am trying to see the content of Container Element!
To do the above taks I did the following
So from MONI I clicked the PE in the INBound, it took me to Workflow Log ,then I clicked one of the Step and it took me to "Display Work Item Screen", in this screen from the Menu Extras --> Container I see one message went in. I clicked that and a window opened below, I right clicked Nested Table --- Messages. But I am unable to see the container Element content
Please help me. Thanks friends.
Hi,
have a look at this document:
https://websmp104.sap-ag.de/~sapdownload/011000358700003141152005E/HowTo_Monitor_ccBPM.pdf
Regards,
michal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I am trying to look a Mapping step in the Work flow log.
Here I double clicked the Mapping and I got a new screen "Display Work Item"
From this screen menu Extras ---> Container and new pop-up screen appeared , where I saw Messages in 1 and I double clicked that and in the lower bottom another window poped up with 1, I right clicked that Nested Table - Messages and I got another window "Display Container elment Messages", I double clciked here and it took me to the MONI .
Thanks for your help.
Karen,
In the container "Dispaly Container element" you wiil have to choose a any message(there will be multiple messages if it is a multi mapping) and double click which will take you to the MONI and only the selected message(1 message) from "Dispaly Container element" will be displayed. Now double click on this message and you will see the contents of the selected message.
Regards
Anand
Message was edited by: Anand Torgal
Anand, Yes I can see that. But I could have seen that in the first place itself, by clicking the inbound message.
What I remember is you can see the container element without even going to the Moni. Even in the PDF that I referred, they are showing the screen shot that xml messsage is displayed immediately .
Thanks for all your help.
Hi Karen,
Even screen shot in the document shows SXMB_MONI (Step 8). But the only difference is SXMB_MONI will shows only the input message to your BPM but if you go through the steps mentioned in the document it will show you the selected message only. This will be useful when you have multiple mapping steps in your BPM or multi mappings. Say you have two mappings in your BPM (MAP1, MAP2). If you directly go to SXMB_MONI and double click on a message it will just show you the input to the BPM.
But if you go through the steps specified in the document it will show you input message to map1, output message of map1 and similarly for map2(input/output). All this four messages input/output for map1 and map2 which cannot be seen directly through SXMB_MONI. only through the steps specified you can see all these four messages.
This will make sense when you have multiple mappings or multimappings.
hope this clears your doubt...
Regards
Anand
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.