on 01-06-2014 1:46 PM
Hii Expert,
I'm loading data to multiprovider 0FIGL_M30 which have two virtual provider 0FIGL_V30 and 0FIGL_V31 and a standard infocube 0FIGL_C30.
The virtual provider 0FIGL_V30 and 0FIGL_V31 are filled by the Function module and infocube 0FIGL_C30 filled by the DTP created on top of 0FIGL_V30 virtual provider.
But when i try to display data of 0FIGL_V30 or 0FIGL_V31 got this error shown in pics.
Looking for your valuable suggestion and solution.
Thanks in advance.
regards
Syed
Hi,
you need to activate from the business content the multiprovider 'FIGL_M20'
After this you need activate too the infocube '0FIGL_R20' with the transformation associated to the data source '0FI_GL_20' and finally generate a DTP for this data flow '0FI_GL_20' --> '0FIGL_R20'
It use this data flow to be able to use the direct mode in the '0FIGL_V30' and so it can load the '0FIGL_C30' or user access type 'R' with '0FIGL_V30'
It has worked for me by doing the following steps.
Regards!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Syed,
Refer to following note:
1371240 No data on 0FIGL_V30/0FIGL_V31 in transaction LISTCUBE
Hope this will resolve your issue.
Thanks & Regards,
Vipin
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
The screenshot is looking for an infoprovider 0FIGL_M20. Make sure the object exists.
Also you can't load data to a multiprovider this is only a structure.
hope that helps
Martin
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi syed,
Multi provider is support union operation,its maintain structure and never contain data.
please check the char and kf assignment in multi provider level.
Thanks,
KV.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You never load data into multi provider because its structure and never holds data.
Seems like one the info oobject which was used in your providers may not be in active or partially active.
object - 0FIGL_M20
Try check data thru tx - LISTCUBE.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.