cancel
Showing results for 
Search instead for 
Did you mean: 

Data not present in IP but available in ECC

shyamala_kalluri
Participant
0 Kudos


Hi Team,

I have asked  MMM team to create the purchase order for the respected Material and Plant in ecc system  but when i ran IP for that datasource i didnt fetched the PO which thy have created.

could you pls help me that  what should i do to fetch the data in BI system.

BR,

Shyamala.V

Accepted Solutions (1)

Accepted Solutions (1)

former_member182516
Active Contributor
0 Kudos

Whats the data source you are trying to extract the data load?

Are you extracting Full load or delta?

Is it the first time you are extracting the data using the LO data source then you need to delete the setup tables and fill the set up tables and next try to trigger the IP.

Regards

KP

shyamala_kalluri
Participant
0 Kudos

HI KP,

2lis_02_SCL is the DS with full load.

no this is not the first time  that we extract the data fom LO

BR,

Shyamala.V

RamanKorrapati
Active Contributor
0 Kudos

Hi,

Whenever you do full load you need delete and refill setup tables. other wise latest records which were changed after the last fill of setup tables won't be coming thru.

I think your data source may supports delta(ABR type). if yes then why your not loading delta loads.

Thanks.

former_member182516
Active Contributor
0 Kudos

You mean to say the document was not fetched in delta load?

What is the change that they(MM consultant) had made ?  Have you tried to trigger the data load after a specific time for ex : after 30 mins from the MM consultant created n saved the document.

Regards

KP

former_member209606
Participant
0 Kudos

hi

first do the LO extraction in ECC and try to load the data in BI...

former_member182343
Active Contributor
0 Kudos

Hi,

As if it is full load you need to fill setup tables first.

Steps:

- delete earlier setup tables using LBWG.

- Clear RSA7 by running infopackage twice and delete delta enable datasource from RSA7.

- Take down time(if you are doing prod system)

- Fill setup table for Purchasing  - OLI3BW

Run job in background

- Then run infopackage with full load.

- Then test data with ECC table, whether your desired records has pulled to BI or not.

- Enable delta for that datasource.

Best wishes, Vijay

Answers (1)

Answers (1)

RamanKorrapati
Active Contributor
0 Kudos

Hi,

for full loads have you filled setup tables in case of LO Data source.

if its delta then you can check at RSA3, with delta mode and check it. whether it pulls or not.

for delta loads have you set V3 update incase of LO data sources.

Thanks