unable upload data from 0CO_OM_OPA_6 -> 0COOM_C02

[Former Member]

Hi all,

• I am trying upload data from inforpackage to cube (0C00M_C02)
• when trying to upload 0CO_OM_OPA_6 -> 0COOM_C02, i am unable upload it to cube. it show 0 data record(only from  0CO_OM_OPA_6 -> 0COOM_C02)
• but, data is available for Inforpackage . i tried with everything but no luck. Please help me to short this out
• please refer to screenshot

Thanks

Mirana

[Former Member · Accepted solution]

Hi all,

I shorted this out. we need to upload 0COORDER Master Data before upload the data into 0COOM_C02.

Thanks

Mirana

[Former Member]

Hi,

As you can see, the problem lies in the TRCS step in the update rules.. There you see the number of records going from 10k to zero.. Is there any specific ABAP in that step that might cause the deletion of records in your data_package on some conditions?

Sjoerd

[Former Member]

Hi S.Van

this is standard one. i did not do any ABAP modification for TRCS.  but CCA_9 and CCA_1 are working fine.

Thanks

Mirana

[former_member183012]

Hi Mirana,

Have checked setting of infopackage incase of you are in 3.5 or DTP setting?

If your infopackage loads data that means it should load to datatarget also.

can you please check the setting once?

wheather data comes to pSA if not that means your routine deletes the data.I am agree with s.Van.

Regards,

Ganesh Bothe

[Former Member]

Hi Ganesh,

Data is coming to PSA. but can not be uploaded to target. all the symbols are in green color, so even it is very difficult to track down the error as status is green.

Thanks

Mirana

[former_member183012]

Can you check the data taget tab of your infopackage ..have you selected mentioned cube?

one more thing open your update rule or transformation and check start routine is present or not?

you are getting 0 recors because of start routine..please check.

Regards,

Ganesh Bothe