on 10-18-2005 12:36 AM
Hi everyone,
I am doing the bdc for tcode F-58 based on the parameters given by SM35. When I run it with the program, it suddenly stops showing the error message, "Field BKPF-BLART not found on dynpro sapmf05a 0129". I need to set the bkpf-blart field to a specific one (electronic payment) but it seems bdc doesn't allowed me to do such a change. do you know how does this happens or how can it be solve, or where can i take a look ?
Thanks on any advice.
Silvia
BKPF-BLART is very much there on the specified screen SAPMF05A 0129.
although quite a few FI transactions behave differently when run normally compared to when a recording is done on them, i don't think this transaction will fall in that category (especially this field). check your code once again.
rgds,
PJ
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
What release are you on? In our 4.6C system, BKPF-BLART is not on SAPMF05A 0129; but the payment method is OPAYF-RZAWE on SAPMF05A 0130 (the initial screen).
Rob
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
you need not fill field bkpf-blart.
-> it's customized with TA <b>OBU1</b>
regards Andreas
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi,
check the field BKPF-BLART is exist in the dynpro
sapmf05a 129. using F1 find out the correct screen and screen no for the particular field.
cheers,
sasi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.