cancel
Showing results for 
Search instead for 
Did you mean: 

Why other delivery schedule component lines not appear in ME2O

Former Member
0 Kudos

Hello,
I have a question with regards to the line appeared in the ME2O corresponds to my delivery schedule lines in my Schedule Agreement (SA).

The following is my delivery schedule in my SA.

The relationship between the parent (#0001062) and child (#02210349) in the BOM is 1 to 1.

The following are the ME2O display when I run it for the subcontract vendor and the parent material.

In order for better view, I combined the two above screen into one following, and you will notice that ME20 only proposes those Delivery Schedule Lines indicated in yellow.

Question:
I look through the delivery date between two screens and it seem doesn’t make any sense  as to why those white color lines were not proposed in the ME2O screen, does it means those components in white row does not need to replenish to the subcontractor, if yes, it doesn’t make sense to me, and am sure I am missing out something. Do you know?

The following is the MD04 for the parent material, and highlights below are proposed in MD04 screen of child component, which also shown in ME2O screen for the child component:

And the following MD04 is the child:

Regards,
Daniel

Accepted Solutions (1)

Accepted Solutions (1)

Petepall
Contributor
0 Kudos

Hi Daniel,

As Tao suggested please create a new release and then check again.

If you look at your screenshot of me38 and check the screenshot of ME2O you should detect the issue.

The items I marked in green are the ones that are showing in ME2O, this is because these items have been released and thus are known to the vendor.

In general I always tell users if you want to compare data with a vendor or in this case with ME2O then don't check against the ME38 schedule line proposal but check against the effective last release sent to the vendor which you can check via ME38 and then looking at the fully transmitted (green light) delivery schedule.

Regards,

Peter

Former Member
0 Kudos

Hello Peter and Tao,

I tried run the release ME84 below, but..

However, I am getting this error code red message 26 - No data for choosen selection

Any clue?

Daniel

Petepall
Contributor
0 Kudos

Hi Daniel,

Please de-activate the test run check box and try to sent it with scope of select 4

Currently the release is being generated with setting Changed or next date.

This means that if you have already generated a release say in ME38 today and you try to sent it again today but there is no change in the requirements then with this setting no new release is generated,

Also check if your selection combination is OK, meaning plant code together with the material, vendor and scheduling agreement combination does this exist?

Former Member
0 Kudos

Peter,

My bad, it works now.

Unfortunately, the ME2O still not showing the components to supply for those records highlighted in non-yellow color (see previous figure).

Hence, after the release, the scheduling line (in red square) which previously shown blank now appear with value.

but the ME2O remains unchange? this is still not correct as the child component of (#02210349) should appear in the ME2O for those records generated.

Hope you or tao can shed some light here.

Dan.

Petepall
Contributor
0 Kudos

Daniel,

Please check FAQ note 458938 and more in particular question 4.

This points to another OSS note 385565

Former Member
0 Kudos

Thanks Peter,

I will see if the OSS provide the correct answer.

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi Daniel,

Try to use t-code ME84 to create a new SA release version for #5500000086, and then try to review with t-code ME2O again. Hope it's helpful for you.

Best regards

Tao