Skip to Content
avatar image
Former Member

HTTP Adapter

We are sending our PO's to our Vendors using the HTTP Adapter (on the Receiver Side). This is an Asynchronous Call.

When the server is down at the Receiver or Vendor end, then we are getting HTTP 400 error code and when I reprocessed that after some time it went thru fine, because the Receiver server was UP.

MY question here is, if there is any Mechanism to RETRY for so many number times, or so many hours etc. Currently we are not using BPM.

Thanks for your support

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Oct 12, 2005 at 02:37 PM

    Hi Karen

    The following note will be of help to you,

    813029

    cheers

    Sameer

    PS: We can set the Integration Server to automatically retry and deliver any messages failed due to a communication issue.

    SXMB_ADM --> Integration Engine Configuration --> Specific Configuration

    IS_RETRY_LIMIT = 25

    This will force the Integration Engine to try 25 times with an interval of 2 minutes. The retry minutes are not changeable.

    Message was edited by: Sameer Shadab

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Thanks everyone, you made my day.

      Currently I have Category = Tuning , Parameters = IS_RETRY_LIMIT and Current Value = 25.

      So I belive the Current Value , in this case 25, will make the IS to retry 25 times, if the Receiver URL is down, correct? Also whether it is possible to set the Time interval, before we poll for the next attempt?