DP - Alerts

[Former Member]

Hi all,

In my selection i have excluded one particular SBU and in the Planning job, when i select the SBU at the aggregation level, ( which is only way i could get get alert excluding one of the SBU) - the job just runs for a long time.

When i dont select the SBU in the aggregation level and run , the planning job gets completed. But my alerts are wrong.

So i created another selction Including only the SBU which i excluded earlier and i ran for a few materials and it does not take much time, but when i run the all , the job just keeps running.

Any idea on how to solve this?

Regards,

Rorie

[former_member187488]

Hi Rorie, if you do not set excule the SBU, and run the job with all settings the same, what would be the result?

Analysis with ST12 tool will help here I think.

[Former Member]

HI Ada,

I tried that. The problem is that when i include SBU in the aggregation level, the job just takes a very long time.

But have solved this by adding some additional steps in the process chains by Zeriong out a keyfigure and adding some macros.

Thanks.

[ravi_malpani]

Hi!

It is incorrect to not select SBU in aggregation level and use SBU as selection criteria. Am not surprised that the alert results are wrong.

To avoid higher run time you can make use of parallel processing profile while creating the background job. Or else run different variants of the job either in parallel or series.

Regards,

Ravi

[Former Member]

Hi Ravi,

we use the parallel processing, have tried all the combinations with different number ranges , but when i include SBU in Aggregation level, it just takes a very loooong time. Is there any other suggestions/

[ravikumar_ambadipudi]

Hi Rorie,

By looking into thread didn't get the exact point / issue

could you please let me know the your requirement regarding DP Alert wihch you are running with SBU

Regards

Ravi Kumar A