Hy all,
the situation is the following:
i attempt to create a variable of type "hierarchy node" (for cost center cha) in my planning area, i used the replacement type "user defined value", check on "input allowed by user" and then i create the user entry, in selection condition i run match code and when i try to select a single cost center (not a hierarchy node) expanding the hierarchy tree the system goes dump with the following message:
-
Runtime Errors MESSAGE_TYPE_X
Error analysis
Short text of error message:
Program is inconsistent -> see long text
Technical information about the message:
Diagnosis:
An inconsistent program status has occurred. The program cannot be continued.
System response:
The system crashes.
Procedure
1. Look in OSS for a note under the error message UPC099.
2. When you open a problem message, send the first pages of the
system crash message including the section 'Source code excerpt
' with the message.
Procedure for System Administration
Message classe...... "UPC"
Number.............. 099
-
Selecting a hierarchy node (not a single cost center but a text node grouping more cost conter) this problem does not occur.
I appreciate (and reward) any hints.
Thanks in advance
Fabio