"No Objects found" in Interface Mapping

[Former Member]

Hi,

I am working on a simple BPM synchronous scenario as follows

File>XI>RFC (request)

RFC (Response)>XI>File

I have done almost everything fine, but while configuring the Receiver determination, I am able to choose the Inbound interfcae, but when I try to select the "Interface Mapping" for the same inbound interface,

it says "No Objects found".

Can anybody help me out in this regard?

I would very much appreciate your help in this regard.

Thanks in advance.

Regards,

Rambabu

[Former Member]

I have resolved the issue myself.

Thanks,

Rambabu

[Former Member]

You might have created a message mapping but not Interface mapping.

regards

Shravan

[Former Member]

Hi Shravan,

I have resolved the issue. In fact there is no mistake done in Repository. In Configuration, I haven't selected the appropriate service, because of this, I wasn't able to see the objects.

Thanks & Regards,

Rambabu

[Former Member]

hi,

make sure in repository there is an active interface mapping for the inbound interface.

Naveen

[Former Member]

Hi Naveen,

I have resolved the issue. In fact there is no mistake done in Repository. In Configuration, I haven't selected the appropriate service, because of this, I wasn't able to see the objects.

Thanks & Regards,

Rambabu