on 10-07-2005 9:33 AM
Hello!
I need to load my key figure with the unit of measure diferent from provided by SAP in 0UNIT attribute, so I want to enter some new values in 0UNIT.
How to do this? (I'm sorry if you will find this question primitive, but I stuck with it).
Thank you!
Hi Denis and welcome on board!
Usually it's better to do this enhancement in source system side, but if you want to add something in BW, you have to do directly on system tables:
T006
T006A
T006B
T006C
T006D
T006I
T006J
T006T
So, I don't think this doc is useful for you (this is valid only at reporting level...), but...
https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/library/biw/g-i/how to report data in alternate units of measure
Hope it helps!
Bye,
Roberto
...please don't forget to reward the answers...it's THE way to say thanks here!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Denis,
THERE IS a way to include new units into the system. Roberto meant that you can enhance the source system. It means that using tcode SPRO - click SAP reference IMG. Then go to tree node SAP Netwear General settings Check units of measurement (or directly execute CUNI t-code) - and you arrive to units of measurement maintenance screen, where you can create new units. You can do it in BW.
But it is also possible in the source system, especially if it is R/3 system. In this case you enhance the source system and using in BW tcode RSA1 - source systems area - right click - transfer global settings you can bring these units into BW.
And Roberto meant that editing your message 'as a question' you could reward helpful answers. It's the way to say thanks in SDN.
Best regards,
Eugene
User | Count |
---|---|
94 | |
11 | |
11 | |
10 | |
9 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.