on 10-06-2005 4:28 PM
I have a scenario where in there will be SOAP message comming in from multiple sender systems. The message format is same. Each one can be distinguished by plant code on the message.I have to load these messages into SAP R/3 using a RFC Adapter.
Is there a possibility in XI that we can define multiple senders (as we can define multiple receiver determination based on condition).
If BPM is the only way to resolve this, can somebody eloborate on the steps needed to be configured in BPM.
Thanks.
hi,
if the soap message format is same for the senders, then ur scenario is very straight forward, you dont need BPM.
just map ur outbound interface to the imported RFC.
Naveen
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
normally the sender service and interface is listed in the receiver determination so there would be one per sender that means even in your case multiple receiver determinations. However you can also use a wildcard (*) as sender in the receiver determination, than you can handle all your senders via one receiver determination.
What you than have to make sure is, that you have one SOAP Channel per sender, so you can create one sender agreement per sender. Multiple sender agreements for one channel are not possible.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.