Skip to Content
author's profile photo
Former Member

Problrm with extract checker RSA3

hi gurus,

when i give the data source name in the 'RSA3' and change the update mode to 'D'(i.e delta). i am getting the following error.

like "Could not determine BW release of logical system"

any idea would be helpful and thanx in advance..

with rgds/loknath.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • author's profile photo
    Former Member
    Oct 06, 2005 at 11:23 AM

    Hi dear!

    You have to add also the logical name of your BW target system in the dedicated field !

    You channels have as key datasource name AND bw destination system (you can verify it in RSA7 columns!)

    Hope it helps!



    ...please don't forget to reward the's THE way to say thanks here !

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member


      in addition to Robertos info, your datasource already has to be assigned to a infosource in a bw system. Otherwise it is not possible to simulate a init or delta load in rsa3.


  • author's profile photo
    Former Member
    Oct 06, 2005 at 11:43 AM

    Hi loknath

    After changing the mode from F to D, Just mention the Bw logical system name in Target sys field.


    System, in which applications run, integrated on a joint databasis.

    In the SAP sense, a client corresponds to a logical system. In the

    definition of a client, you can enter which logical system is a client.

    The logical system is relevant for the following SAP areas:

    o ALE, in general: Communication takes place between one or more logical systems.

    o ALE, distribution scenarios (e.g. cost center accounting):

    Definition of the system in which a certain application is running.

    Master data changes, for example, can only be carried out in this system.

    Workflow objects: The logical system is always contained in the key of an object

    When maintaining the logical system, please note:

    o The logical system must be unique across the group. It may not be

    used by any other system in the ALE system group.

    o The logical system may no longer be changed in the productive system

    if a non-initial has been entered once. If a non-initial logical

    system is changed retrospectively then the system's own documents

    may no longer be found. If the logical system of a document

    reference does not agree with it's own then the system assumes that

    the document is in another system.

    Add comment
    10|10000 characters needed characters exceeded