Issue in Customized Output Type

[reachdebopriya]

Hi Expert,

Created customized output type for PO form.

Created a customized Output Condition using Transaction MN04 with key combination Document Type.

Adobe form is configured in NACE for PO Form using Standard Driver Program SAPFM06P and routine "ADOBE_ENTRY_NEU".

When trying to create Direct PO, it is giving below dump.

An exception occurred that is explained in detail below.

The exception, which is assigned to class 'CX_SY_DYN_CALL_PARAM_MISSING', was not caught in procedure "NNAST_AENDE_CHECK" "(FORM)", nor was it propagated by a RAISING  clause.

Since the caller of the procedure could not have anticipated that the exception would occur, the current program is terminated.

The reason for the exception is: A PERFORM was used to call the routine "ADOBE_ENTRY_NEU" of the program

"SAPFM06P". The current call contains 0 actual parameter(s), but the routine "ADOBE_ENTRY_NEU" expects 2 parameters.

Let me know what is the issue.

BR,

Debopriya Ghosh

[himanshu_gupta13 · Accepted solution]

Dear Debopriya,

I think you didn't assign the condition type to the procedure, please check it out, if it is right then go to nace and maintain the condition type in procedures.

Many Thanks / Himanshu gupta