Skip to Content
author's profile photo
Former Member

Multiprovider Drilldown

Hello people of SDN, I am new to the forum so didnt know where to post, so i am here. Excuse me if its not right place.

I have a multipovider which is built over plan and actual data. I am getting data but when i drilldown i get more data than before. i checked the mapping and all show correct but drilldowns are causing improper results.

Need some expert help i guess. Thank you.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Oct 04, 2005 at 08:19 PM

    Hi Roger,

    Welcome to the SDN! In a multiprovider, the selection and identification process is the key to getting correct data...as you mention, you have already checked this. What improper results are you getting: Numbers incorrect, # values, no data ...? Could you please elaborate.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Thank you for the quick reponse. We have done planning on some plants and materials. One cube has actual data with only some common characteristics and other cube has plan data. The drilldowns we are using are not common to both but i guess is mapped from master data. So is the solution not to drilldown on them or to restrict the chars?? Whatever i do gives improper results.

  • author's profile photo
    Former Member
    Oct 05, 2005 at 07:24 AM

    Can you provide an example with values ?

    Add comment
    10|10000 characters needed characters exceeded