Skip to Content
author's profile photo
Former Member

Restart and Par deploy

Hi,

do one need to restart the J2EE Engine (on WAS6.20) after the deployment of a .par file?

Thanks

Best regards

Kris

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    Oct 04, 2005 at 01:46 PM

    Hi Kris,

    No you need not restart the server after deploying the par file. Just create an iView from this par file and view it.

    If you make some changes in the project and want to redploy the par file then you have to just rebuild the project after doing the desired changes and create a new par file. Deploy it again and the changes done in this newly deployed file will be reflected in the output.

    I hope this solves your problem. If you require some more clarification then please revert back.

    Regards

    Pravesh

    PS: Please consider rewarding points if helpful.

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 06, 2005 at 11:44 AM

    Hi Kris,

    the given answer holds with a certain constraint: Hot deployment of KM components is not supported at the moment. So if you develop something which needs a RFServiceWrapper which adds you PAR classloader to the RF classloader, the result is "undefined" and you have good chances to run in different trouble without a restart (slow-down of EP/KM, KM restarts, OutOfMemoryExceptions, accessing the old implementation)...

    Hope it helps

    Detlev

    Add comment
    10|10000 characters needed characters exceeded