Skip to Content
author's profile photo Former Member
Former Member

Problem during extraction

Hi Expert's,

I am extracting customer (2lis_01_s001).

but it is giving an error and the data is not coming to the BW side.

I checked the RFC connection it is giving as BW unknown in Source System.

Any suggestion in this regard is welcome.

Cheers,

Pradeep

Message was edited by: PRADEEP NAGARAHALLI

Add a comment
10|10000 characters needed characters exceeded

Related questions

2 Answers

  • Best Answer
    author's profile photo Former Member
    Former Member
    Posted on Oct 04, 2005 at 07:24 AM

    Hi

    Could be caused by a lot of things. Could You give some more details...

    First of all try to run an extractors check in R/3 (RSA3) to isolate the error to BW or R/3.

    Regards

    /Frank

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Oct 04, 2005 at 08:08 AM

    Correct the rfc connection and activate the source system connection in bw source system assignment.

    then check the data in source system using tcode rsa3.

    hope this helps.

    mahantesh

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.