0sd_C01 Delta Error

[Former Member]

Hi All,

I installed the 0SD_C01 and did the init delta without data transfer. In R3, when I try data extractor RSA3 for 2lis_01_s001 it extracts 0 records. Also when I try delta load as soon as I do init without data transfer, I get an error. Does this mean I have no data in R3 or something wrong with my delta extraction.

In the monitor I see 'Caller 09 contains an error message'

Further analysis says 'Error in SOurce System'

But I see no errors in SM37, ST22 or ST21 in R3.

Please Help.

Thanks,

Arthur.

[Former Member · Accepted solution]

Hi Arthur,

As you are using the old LIS Structures,

First you have a look at communication tables MCVBAK MCVBAP and so on .Then have a look at 2 tables and One Infostructure,

they are XXXXSBIW1 , XXXXSBIW2 , XXXXSBIWS.

These are transparent tables , BIWS is extract Structure and other two are data tables . u can check the active status of data transfer table in the TABLE TMCBIW

Check in Transaction MC23 and check for the Update Rules, they all should be active .

u can maintain Updating in LBW1 trasaction.

Hope it helps.

Thanks,

krish

*Awarding Points is a way of Saying thanks in SDN

[Former Member]

Hi,

MAke sure that the setup table is not empty.Take a look on the following link , I hope it will give better idea.

With rgds,

Anil Kumar Sharma .P

Assigning points to the helpful answers is the way to say thanks in this forum.

[Former Member]

Thank you Anil.

But 0SD_C01 is not partof LO Cockpit. It is one of the old LIS structures. 2LIS_01_S001. So there are no setup tables. I also found out that I have not installed and extracted data for master data elements(which shouldnot cause problems, since I haven't checked the integrity flag in Info Package).I suspect ithere are no data in R3, when I try RSA3 It extracts 0 data, I just want to make sure that some one point me well in the righ direction.

[Former Member]

Hi,

You are right . For old LIS structures,there are no setup tables.But there are similar tables called Statistical data tables .Which will be used almost similarly to set up tables in LO technic.

For a small idea I have refered the link. So make sure that you have filled the statistical data .If you donot have data in these tables you can not get data in RSA3 also.

With rgds,

Anil Kumar Sharma .P