Skip to Content
author's profile photo
Former Member

Init Load and RSA3

I have carried out a transport to Q/A and part of the transport included an Init InfoPackage which was created on Development. I have used this package to schedule an immediate Init load. It is not extracted anything so far but should have, could this be because the package was created on Development? If so how do I resolve.

As a test I went to RSA3 to see if I could carry out a test extract, nothing is being extracted in the sense that the process is still running, could this be because I am extracting on B/W or is there no relationship in that sense? Thanks

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • author's profile photo
    Former Member
    Oct 03, 2005 at 12:29 PM

    Hi,

    Make sure that there is data in setup tables.

    With rgds,

    Anil Kumar Sharma .P

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo
    Former Member
    Oct 03, 2005 at 12:57 PM

    Hallo

    Form where are you loading. Check with RSA3. If you use the Logistic Extractors, then you need to fill in the set-up tables in Q or Productive ssyte,. You do not need to create another infopackage.

    Where do you get stuck?

    Mike

    Add comment
    10|10000 characters needed characters exceeded