Skip to Content
author's profile photo
Former Member

Two sender of one System

I have added the second channel(SOAP) of sender to my configuration scenario. This channel is configured to work with the same sender interface.

I have added sender agreement of new channel.

But when I sent a message to XI see an error <b>No receiver could be determined</b>

What did I wrong? Is it possible to have 2 active channel of one message interface?

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • author's profile photo
    Former Member
    Oct 03, 2005 at 01:28 PM

    The two channels could be active, but for one message interface you can have only one <b>sender agreement</b> and the 1st <b>channel 1</b> even though it is active, if you go to Adapter Monitor it shows the error <b>no sender agreement found for the channel</b>.

    The <b>channel 2</b> which is assigned to the sender agreement should function properly. If you are getting <b>No receiver could be determined</b>, check your receiver agreement is correctly determined (including namespaces).

    regards

    Shravan

    Add comment
    10|10000 characters needed characters exceeded