LUW

[sachin_kulshrestha2]

Hi,

In My load today one of the request has QM status as YELLOW why?

Every thing is OK the extraction nodes in monitor show error occured. That is because there is a discrepancy between the newly confirmend LUW and number of LUW to be deleted. And because of this the next delta has also failed.

What should i do???

Thanx

sachin k

[sachin_kulshrestha2]

Hi,

Can anyone figure out the reason why there is a difference between the confirmed LUW and LUW to deleted??

thanx

sachin k

[sachin_kulshrestha2]

Hi,

As far as i know if the LUW are confirmed then the data is not transfered in BW again???

or repeat to delta will bring records please confirm.

thanx

sachin k

[Former Member]

Definitly it will bring the records?? i don't understand why you are checking luws and all....no need to look into bw side....whether it is failed/success...if it failes then start repeat the delta....

hope it helps,.

mahaaaaaaa

[Former Member]

Sachin, In your case. If the next delta is failed better delete both the request and repeat the delta whenever the load is less on source system. it will work...

hope it helps.

mahantesh

[S0004647611]

Hi Sachin,

It is possible that some TRFC trafic within the LUW is stuck. If the load is from R/3 check in your source system within Tcode sm58 with filter on your BW logical system name for"TRFC Destination"" if there are broken transfers. You can rerun them with F6. <b>BUT</b> be aware that if you reran the dataload already to correct this problem, re-executing the broken luw could cause doubled data. so double check. If the load was a BW datamart load check the same logic, but only within BW.

Kind regards, Patrick Rieken.

Message was edited by: Patrick Rieken