Skip to Content
author's profile photo
Former Member

Configuring IDOC on R/3 and XI ?

Hi All,

I was following one how-to doc in configuration of IDOC on R/3 and XI.

If we have more than one scenario with IDOC-XI-File scenarios to handle same or different IDOC's.

Where do we configure on R/3 or XI to send IDOC from R/3 to particular Scenario on XI ? I see configuration only tells to send XI on particular port, but it does not tell which sender it is supposed to send?

Please throw some light on this.

Thanks,

Kumar

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • author's profile photo
    Former Member
    Oct 01, 2005 at 07:18 PM

    Hi Kumar

    Have a look at this document, which explains the settings in IDOC-File scenario,

    https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/library/uuid/73527b2c-0501-0010-5398-c4ac372c9692

    cheers

    Sameer

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Kumar,

      Party is configured if the system you are connecting, for receiving and sending data, is not within your landscape. Or there is no information about the party's environment details in the system landscape directory. Then you configure the scenario with the Party if not its Without party. E.g connection to the web service of your client, or to some web address on the Internet etc.

      What you need to do is that if the scenario is same but the logical system in R/3 is different then you can use the Condition within the ID to distinguish the Idoc and route to the corresponding Receiving system, using the receivinger adapter. If its the different IDOC then you have to configure different Scenario within ID for each IDOC scenario.

      Hope this helps.

      Cheres,

      Ranjan