Full Repair Load

[Former Member]

I have made changes to an Update Rule by adding objects which are not part of the Communication Structure. The changes are okay and are ready to be transported. After transport I need to do a load so that the changes implemented are made available to all the records. Do I need to carry out a Full Repair Load so as not to disturb the Delta Load and if so what is a Full Repair Load doing which is different to a Full load. Thanks

[Former Member · Accepted solution]

Hi,

The following link may help..

Regards-

MM

[Former Member]

Check this thread too..

If it is any relevant to your problem..

--Led

[Former Member]

Nitesh,

Couple of q's.

1) What is this infoobject doing in the update rules , if it is not getting any feed from the comm structure (Unless it is equated to a constant)?

As I understand, "Repair Full Load" is used to activate delta on your ODS's.(after your full load is done)

Full load is your regualr full load.

And your question on changes being available to all the records..

Yes--> in case of the new records being loaded using the update rules.

No--> for the records already sitting in your data target.

Hope that helps.

-Led

-Led