Skip to Content
author's profile photo
Former Member

File Sender and Receiver

Hi,

As per the weblog /people/venkat.donela/blog/2005/03/03/introduction-to-simple-file-xi-filescenario-and-complete-walk-through-for-starterspart2, I did follow the steps. I configured serv-u FTP server for my local system. I gave my systems Ip Address, c:\FTPServer as the directory to be used.

In FileSender Adapter, I gave all the details...but still it is not working. Is there something else I am missing?

Please advice.

Thilothama

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • author's profile photo
    Former Member
    Sep 29, 2005 at 04:42 PM

    What have you specified in the "targetdirectory" of FTP commn channel. It should be the logical folder and not c:\FTPServer, hope you have taken care of it.

    Also , better chk if that folder allows "anonymous" access

    cos , if u had gone by the blog u mentioned , it talks of using an anonymous user. better always create a FTP user

    make sure you have read/write permissions on the folder when u login as this user.

    BTW What is that you are seeing in the adapter monitoring ?

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Did you check your Adapter Monitor ?

      If not go to adapter monitor for XI SP > 09

      http://<host>:5<sysnum>00/rwb -> Component Monitoring -> All Display -> Adapter Engine -> Adapter Monitor

      XI SP <= 09

      http://<host>:5<sysnum>00/AdapterFramework

      Check whether your adapter is active or not.

      regards

      Shravan

  • author's profile photo
    Former Member
    Sep 29, 2005 at 04:16 PM

    Could you please explain explain what is not working, the file is not working / mapping not working ??

    regards,

    Ravi

    Add comment
    10|10000 characters needed characters exceeded