Skip to Content
avatar image
Former Member

Wrong Values in DP Planning Book for BASE UOM different than PA UOM

Hi,

My Base UOM is PAC and my Planning Area UOm is PC.

In the Material Master i have a conversion of 5 PC = 1 PAC.

I have loaded the data in Cube in UOM PAC say 415 PAC.

BUt when i load this data in Planning Book using TSCUBE i can see value as 83 instead on 415.

I have maintained the UOM tick in the PA for DP.

I want that the qty should be 415 in my PB

Can someone guide me from where this 83 came and waht should i do to get 415.

thansk

Raj

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Sep 24, 2013 at 11:54 AM

    Hi Raj,

    What is the UoM in your Planning Area? It seems, the UoM in your Planning Area is PC. That is why whatever you loaded from Infocube (in PAC) is loaded as PC in Planning area.

    While displaying that in planning book in PAC, it is converting the 415 PC to 83 PAC and that s how you are getting the value 83.

    Please make sure you load the planning area with UoM - PC instead of PAC, if you have UoM in planning area as PC.

    Regards,

    Manimaran M.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 24, 2013 at 11:32 AM

    Dear Raj,

    you loaded the data in pieces or PAC.

    If you loaded the data in pieces i.e.,415,it can be 83 PAC..Because 83*5=415 pcs.

    Please check hoe you loaded it,if it is pcs its correct only.

    Please check is it PCS or PAC?

    Thanks,

    Naga.


    UOM.JPG (59.8 kB)
    Add comment
    10|10000 characters needed characters exceeded