inventory cube enhancement not displaying data for enhanced objects

[Former Member]

Hi,

I have enhance the 3 data source to bring profit center and cost center

i followed the below steps

No	Steps
1	Fill 2lis_03_bx setup table
2	Fill setup table for  2lis_03_bf ,2lis_03_um
3	Load initial with  for 2lis_03_bx to BW
4	Compress with mark update
5	Load init without data transfer for 2lis_03_bf
6	Load full rep full data for 2lis_03_bf
7	Compress with No mark update
8	Load init without data transfer for 2lis_03_UM
9	Load full rep full data for 2lis_03_um
10	Load test delta

After the load, i am getting the  new added field as # and posting date as current date

How to fix it

[Former Member]

Hi Hoa,

The steps which you mentioned in your query are related to loading of data to cube. As RK  and Anshu mentioned check in RSA3 Tx at ECC side. Check whether your enhanced fields are getting pulled or not.

Thanks,

Karan Lokesh

[MGrob]

Hi

Check 2lis_02_BX, _UM and _BF in Tx RSA3 and see if you get profit center and costcenter from ECC or if your enhancement in ECC is the problem.

Martin

[anshu_lilhori]

Hi,

Please let us know which datasource you have enhanced.

Also for all those enhanced fields are you getting the data in RSA3.

Regards,

AL

[Former Member]

Hi Ansu, Martin , Karan,

The data is coming correctly till PSA. The problem happens after it loaded into the cube.

Advise how to proceed

[Former Member]

Hi Ansu, Martin , Karan,

The data is coming correctly till PSA. The problem happens after it loaded into the cube.

Advise how to proceed

[MGrob]

Hi

Is the mapping for 0PROFIT_CTR and 0COSTCENTER made in the 3 transformations to the cube?

Martin

[Former Member]

The mapping are done in Transformation. Initially before the marker update the values are reflecting correct. after the marker update the values are not populating

[MGrob]

So your problem is not that you don't get the data for costcenter/profitcenter but inventory value were wrong. Did you follow those steps for compression? http://scn.sap.com/docs/DOC-15987 Page 10-14. Make sure you untick the no marker update for the BX compression

hope it helps

Martin

[RamanKorrapati]

Hi Hoa,

From all these data source we are loading data into cube. so you don't need to enhance 3 data sources. you can enhance only one data source.

At ECC system, Tx - RSA3, enter you data source and check mode as F and Delta.

Whether its pulls data or not. if you see data at RSA3 then we can check at bw side(PSA).

Thanks