Hence the data come from for DSO WM_DS05?

[Former Member]

Hello,

I have the same question as in this post : http://scn.sap.com/thread/588537. Hence the data come from for DSO WM_DS05? I generated it from BI content and there is no transformation and It's not a DSO updated directed.

Thanks!

[Former Member]

Hello,

DSO 0WM_DS05 is associated with EWM Module( Extended Ware house management) Its all togoehter a different module. Hence in your BW you will have a new source system. Just like you activate Data Source in ECC you have to activate it in EWM and then replicate in BW.

The DS for 0WM_DS05 are 0WM_WT_WO or 0WM_WO. Usually this DSO is feeded from 0WM_WT_WO.

I hope this was helpful.

Regards

Rohan

[former_member182470]

Actually, 0WM_DS05 DSO can be loaded from the below two datasources. A complete help documentation is available with key word 0WM_DS05 in help.sap for transformations etc..

0WM_WT_WO - Ware House Tasks

0WM_WO -  warehouse Orders

[former_member182470]

Check my reply and try in help.sap

[Former Member]

I already did it but there is written this :

The following delta update is supported for this DataStore object:

•   Delta update:
•   DataSource:

There is no information about sources.

[former_member182470]

Check the datasources section in left side in the link. You can see corresponding DSO : 0Wm_DS05 in DSO section.

http://help.sap.com/saphelp_afs64/helpdata/en/ed/827db9b7ac447aabf67d71a4488550/frameset.htm

[anshu_lilhori]

Hi,

Check this datasource

0WM_WT_WO

Regards,

AL

[MGrob]

Good point  0WM_WT_WO is related to Warehouse Tasks the one I mentioned 0WM_WO to Warehouse Orders but both feed 0WM_DS05. We only used it for orders info.

Martin

[Former Member]

There is no datasource named 0WM_WT_WO or 0WM_WO. I think I have a missing module.

[MGrob]

Hi

Did you check in RSA5 in ECC? Do you have the WM module?

Martin

[anshu_lilhori]

This message was moderated.

[RamanKorrapati]

Hi Corbel,

Above mentioned data source names by mates, you can find them at Ecc Side Tx - RSA5, expand all and find data source name.

At any cost at RSA5 you will find warehouse management application name. if you won't find data sources then you need to set at Tx - SWF5, need to use respective  business function to make active. then only those data sources will be visible.

Some times available patches may be insufficient in that case need to install higher versions of ECC.

Thanks

[Former Member]

We have activated the WM module in ECC but there is nothing in RSA5. The transaction "SWF5" does not exist. It's possible than we are not up to date with our patches. I think we must to make an update to have datasources.

[RamanKorrapati]

Hi Corbel,

T code - SFW5/SWF5, we need to make active respective business function.

Mean while check table - ROOSOURCE at ecc side, OLTPSOURCE 0WM*.

check it whether its display any result or not. if not then above step is needed.

Even though not available then think about update patch and sap help.

Thanks

[MGrob]

Hi

The datasource you are looking for is 0WM_WO there is also a transformation to that DS.

hope it helps

Martin

[former_member182470]

This message was moderated.

[anshu_lilhori]

This message was moderated.