SPL Tolerance

[Former Member]

Hello everyone,

am an SD consultant and learning GTS as well. Recently they made some changes for SPL tolerance from 60% to 66.66%. I'm aware of the impact but not sure how can we configure this set up in GTS system and using which tcode we can change this set up. this would be of great help. Thanks in Advance

Krishna

[former_member648253]

Dear Krishna,

Please check the node:

SPRO> GTS> Compl mgmt > SPL Screening > Define control proc for address comparision

Select your comparison procedure and click on Detail control.

there you can see these % under Minimal similarity..

Hope this helps.. thank you,

Venkatesh SP

[Former Member]

Hello Anil,

thanks for the reply, one more clarification.. I think in our project it's configured for name but not for address.. We have to follow the same to configure it for name?